Rebooted the ring/Eero router and it works Set to pass through and enter MAC Address.Īs in the video I left the BGW210 wireless on in case I need to get back into the device if I'm having connectivity issues or Eero system isn't working. ![]() So I spent a few hours over the weekend figuring out how to set up the system including putting the BGW210 into pass through mode following this YouTube video: ![]() I was getting around 450 mbps when I ran speed tests near the modem/router combo which is on the second floor before setting up my ring system. The main improvement I was hoping for were better speeds throughout the house (especially on the rooftop deck which is pseudo 4th floor that I stream movies/sports on) since even thought I have AT&T Fiber they still gave me the BGW210 router which as I understand does not support gigabit speed. My thought process was that even though I was getting pretty good speeds all throughout my 3 story townhouse that setting up mesh would improve it slightly once I add access points, and since I needed a security system that I would kill 2 birds with one piece of tech. I was trying to pick a home security system and ended up picking the Ring Pro since it also is supposed to work as a WiFi 6 mesh system. ![]() I'm hoping for a bit of guidance on if the setup I am now using makes sense or not as I still have about a week and a half to return my system to BestBuy. I apologize in advance if some of the below questions are a bit dumb, I have beginner to slightly above beginner level networking knowledge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |